In order to create great and smooth 360 or 3D animations, your turntable will have to be correctly calibrated.
Generally, it is originally calibrated, but maybe you will have to do it by yourself.
Here is the handling:
● Click on the main menu on the top right of the software
● Open the HARDWARE menu
● Next to the connected device, click on the wrench button
● Follow the instruction from the software
The software makes a first 360 rotation.
If it goes back to its initial position, you won't have to adjust it, just click on NEXT.
If it is not, move the turntable
with the control arrows
until it is correctly placed then click on NEXT.
The turntable will make another 360 rotation to ensure the good calibration.
Here you are, your turntable is ready to use!
Related Articles
05. The software doesn't detect the PackshotCreator R3 turntable
This article is only for the PackshotCreator R3 systems. If you launch the software and you can't access to the 360 or 3D mode, your turntable is maybe not detected by the software. It happens sometimes: the turntable has moved from its original ...
03. Driver issue - Update EXAR Driver
Problem / Situation: · For a 360° capture with 8 images: PackshotSpin turntable took one picture then continually spun. Customer had to force quit the software. Later, the camera took 8 pictures, but the turntable never moved. (Customer was ...
05. PackshotSpin O3T turntable will not rotate and makes a noise
Problem: PackshotSpin O3T turntable will not rotate and makes a noise. Note: The noise you hear when the motor is turning but the turntable is not spinning will not hurt the device. Cause of problem: The turntable was stored incorrectly with a ...
07. Exporting animations with the old HTML5 strucure
In February 2018, PackshotCreator released a totally new software version. Beyond multiple new features, PackshotCreator improved and reinforced his algorithms for a better user experience. During this upgrade, HTML5 structures have been ...
19661700030009
This error code is for PackshotCreator R3M360, R3L360 et R3L360T. When you launch your software, you have to calibrate your turning table after installation in order to check if it’s properly connected to the rotation dispositives. If this error ...